Installation; Installing/Replacing The Lamp - EuroLite Follow Spot SL-575C User Manual

INSTALLATION

Installing/Replacing the lamp

For the installation, you need one HMI 575 SFc-10 lamp.
The lamp must only be changed when wearing appropriate protective clothing (protection glasses, protection
gloves, helmet with sight, leather apron).
The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp or check the operating hour meter (if available) regularly and replace the lamp in
time.
Keep exchanged lamp in a protective container and remove accordingly.
During the operation, the lamp reaches temperatures of up to 1000° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Open the housing by loosening the knurled screw in the front of the housing cover and remove
the cover.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder. Pay special attention to the direction of the lamp when
inserting it. The nose of the glass bulb must be pointing upwards or downwards.
Step 4: Replace the housing cover and tighten the knurled screw.
Mount the SL-575C on the stand.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened cover!
21/28 00054421.DOC, Version 1.0