Table of Contents
Advertisement
TRANSPORTING
Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the trimmer on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
1. Turn the engine switch to the OFF position.
2. Make sure the fuel cap is securely tightened.
3. Install the wheels in the transport position for greater ground
clearance and ease of movement.
Loading
The trimmer may be
secured by suitable
clamps, hangers or
straps. Secure the
trimmer by at least two
points along the frame
pipe. Avoid securing the
trimmer by the engine,
cutting head/gear case or
handle area. The trimmer
should be secured in a
horizontal position, with
the engine upright as
shown.
Don't hang the trimmer by the gear case or cutting head, or they may
be damaged.
STORAGE
Proper storage preparation is essential for keeping your trimmer
trouble free and looking good. To help keep rust and corrosion from
impairing your trimmers function and appearance, and to make the
engine easier to start after storage, follow the instructions described in
this section to:
• Drain or treat the fuel
• Change the oil and coat the engine cylinder
• Clean the trimmer and engine
• Choose a storage location
Fuel
See "AVOIDING FUEL-RELATED PROBLEMS" on
recommended procedures to avoid fuel related problems.
The DISTRIBUTOR'S LIMITED WARRANTY
cover fuel system damage or engine performance problems resulting
from neglected storage preparation.
24
Draining the Fuel Tank and Carburetor
Disconnect the spark plug cap. Make sure the ignition switch is in the
STOP position.
Drain fuel from the tank into an approved container. Press the primer
bulb several times to draw any fuel out of the carburetor back to the
fuel tank, and then drain this fuel from the tank.
Oil
Change the engine oil (see
Add oil in the engine cylinder to prevent rust.
Cleaning
1. Disconnect the spark plug cap from the spark plug.
1. Wash the trimmer, including the area around the trimmer head.
2. Wash the engine by hand, and be careful to prevent water from
3. Water on a hot engine can cause damage. If the engine has been
4. If using a garden hose or pressure washing equipment to clean the
page 28
for a list of
5. After washing the trimmer, wipe dry all accessible surfaces.
(page
30) does not
6. Reconnect the spark plug cap and start the engine outdoors. Let it
7. After the trimmer is clean and dry, touch up any damaged paint,
WARNING
Gasoline is highly flammable and explosive, and you can be
burned or seriously injured when handling fuel.
• Stop the engine and let cool before handling fuel.
• Keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.
page
1. Remove the spark plug
(page
2. Pour a 1/4 teaspoon (1 cc) of clean engine oil into the cylinder to
keep it from rusting.
3. Pull the starter rope several times to distribute the oil in the
cylinder.
4. Reinstall the spark plug.
5. Pull the starter rope slowly until resistance is felt, and then return
the starter grip gently. This will close the valves so moisture
cannot enter the engine cylinder.
entering the air cleaner.
NOTICE
Using a garden hose or pressure washing equipment can force
water into the air cleaner. Water in the air cleaner will soak the
filter and can enter the carburetor or engine, causing damage.
running, allow it to cool for at least 1/2 hour before washing.
trimmer, be careful to avoid getting water into controls and cables,
or anywhere near the engine air cleaner or muffler opening.
run until it reaches normal operating temperature to evaporate any
water remaining on the engine. Stop the engine and allow it to
cool.
and coat other areas that may rust with a light film of oil.
16).
17).
Advertisement
Table of Contents
