Troubleshooting Guide - Ocean Technology Systems MilCom 6000D User Manual

TROUBLESHOOTING GUIDE

Contact Ocean Technology Systems for any issues not listed
below:
Issue
No/Low Transmit
No Receive Volume
Scrambler setting "stuck"
Transmission setting "stuck"
on PTT
No Side Volume
Charger LED illuminates
green but the unit LED does
not activate
Charger LED illuminates
green, unit LED illuminates
red, but the unit will not
activate when submerged.
Short Battery Life when fully
charged
Flooding in battery com-
partment
Flooding in electronics
compartment
Unit LED activates with
no start up volume and no
transmit or receive
Step 1
Change E/M to isolate issue
Change E/M Adapter
Move Mic Close to lips
Ensure Transducer is not
covered by equipment
Change Transducer
Change E/M to isolate issue
Change E/M Adapter
Ensure Transducer is not
covered by equipment
Change Transducer
Reduce distance to divers
Battery is "dead". Replace the
battery.
Replace the battery.
Replace the battery. (See page iv for safety warning on han-
dling a flooded battery compartment)
Do not attempt to power on the unit. Contact OTS.
Contact OTS for replacement
Step 2
Contact OTS.
Contact OTS.
Contact OTS.
Contact OTS.
Contact OTS.
Contact OTS.
Contact OTS.
13