Ocean Technology Systems MilCom 6000D User Manual page 11

EARPHONE/MICROPHONE (EM) CABLE
5
The EM cable connects the EM Connector to an EM assembly with an
8-pin connection. The threaded locking collar can be tightened to make a
secure connection to the MilCom unit.
TRANSDUCER ASSEMBLY
The Transducer Assembly acts as the "antenna" of the unit. Transducers
are replaceable.
TRANSDUCER RING
The Transducer Ring is a rotating locking ring that secures the
Transducer or Transducer Cable (TCA-35S) when used with the CDK-6
Surface Conversion Kit.
EARPHONE/MICROPHONE (EM) CONNECTOR
The EM connector at the top the unit connects the MilCom to an
EM assembly and to the battery charger. Modularity allows for easy
replacement for repairs or optional cable assemblies.
MAIN HOUSING
The main housing of the unit contains the electronics and battery
compartment of the system. The connectors to the Transducer and the
Earphone/Microphone cables are user replaceable. The Belt Clip located
at the back of the unit is also user replaceable. Do not disassembled
the main housing beyond this point. Doing so could potentially void any
warranties. The main housing should only be accessed by an authorized
technician.
BELT CLIP
The belt clip can be mounted on a belt or on a BCD tank strap. For best
range between divers and surface station, it is recommended to mount
the unit as far back on the tank strap as possible.
RECHARGEABLE LITHIUM-ION BATTERY
The Lithium-Ion battery provides power to the MilCom unit. The battery
is located on the lower cavity of the unit on a strip of Velcro inside the
Rubber Armored Base. This battery does not require any maintenance
other than charging.