Making Adjustments - Ocean Technology Systems MilCom 6000D User Manual

MAKING ADJUSTMENTS

8
The MilCom uses a voice menu system. This allows for adjustments of
settings without the need for buttons or knobs penetrating the housing.
Using a sequence of easily learned manipulations of the Push-To-Talk
(PTT) button on the Earphone/Microphone Assembly allows you to
control all of the features of the MilCom. It's recommended that you
take a few minutes and learn how to use the voice menu and all of the
features.
To change your settings, depress the PTT button of the Earphone/
Microphone Assembly three times about ¹⁄2 seconds apart, holding the
button down on the third press for around one second. A "beep" tone will
be heard. Press the PTT button three additional times within five seconds
and hold on the third press for around one second. The MilCom will
now enter an adjustment mode. You will hear a voice saying "Channel,
Volume, Scrambler" This message will repeat a second time and exit
if no selection is made. To select an option, press the PTT button once
when you hear the setting you want to change. This will prompt a sub-
menu that will read additional choices. A table of the complete menu is
provided. Depress the PTT button again whenever you hear the option
you want. Once a change has been made, the unit will repeat your choice
then exit.
For example, to change the volume setting to "MEDIUM", you will push
the PTT control three times holding the third push for approximately one
second, then release the PTT button. A "beep" tone will be heard. Press
the PTT button three additional times within five seconds and hold on the
third press for around one second. The Voice Menu will start reading your
options and you will hear: "Channel, Volume, Scrambler"....When you
hear "VOLUME, you would depress the PTT button. This will trigger a
sub menu giving you your choice of volume (see page 10 for explanation
of VOLUME). If you want to hear the messages coming in at a MEDIUM
volume, the unit will give you the option to choose Volume settings (i.e.
Low, Medium, High, Extra High). Once the selection is made, the MilCom
unit will read back a confrimation of the changed setting then exit.