Table of Contents
Advertisement
START-UP GUIDE
7
Before diving, ensure the Lithium-Ion battery is fully charged.
To charge the battery, remove the Earphone/Microphone (EM) cable by
unscrewing the locking collar that retains the cable to the connector in a
counter-clockwise direction on the top of the housing. With the collar free,
grip the connector and pull straight up WITHOUT twisting to disconnect
the cable. Then, connect the battery charger to the corresponding
connector on the MilCom.
When connecting the Battery
Charger Cable to the MilCom unit,
take caution when mating the
connectors. Ensure the two larger
guide pins are correctly aligned
with the two larger sockets. Do
not force the connectors to mate.
Connection should be smooth
when the pins are aligned with
the sockets. Excessive force
could result in connector failure or
breakage.
When the Battery Charger is
connected to the unit, the LED on the Battery Charger will turn GREEN
then switch to RED if the battery requires a charge. If not, the LED will
remain GREEN to indicate the battery is full.
The LED on the MilCom unit is a single color LED. When lit, it indicates
the unit is charging or activated.
Disconnect the Battery Charger from the unit and connect your EM Cable
to the EM Assembly connector.
Your MilCom is now ready for use.
The unit was designed to automatically turn on when it comes in
contact with water. The two metal posts between the transducer and
the connector on top of the unit are the water switch. To check or adjust
your settings prior to dive, the unit can be turned on by placing a metallic
object (like a small screwdriver) onto the two metal posts. Remove the
metallic object after you have confirmed your settings.
The unit will automatically shut off after 30-40 seconds. Do not leave the
metallic object on the unit as doing so will drain the battery.
Advertisement
Table of Contents
