Advertisement
Battery Replacement
• Open the fasteners on the back of the toy.
Remove the electronics box from inside
the toy.
• Loosen the screws in the electronics box
battery compartment door with a Phillips
screwdriver. Remove the door.
• Remove the exhausted batteries and dispose
of them properly.
• Insert three, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• Fit the electronics box back inside the toy.
Make sure the button on the electronics box
is facing the front of the toy.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and then back on.
• When sounds or light from this toy become
faint or stop, it's time for an adult to change
the batteries.
1,5V x 3
AA (LR6)
For longer life, use
alkaline batteries.
Power and
Mode Switches
• Slide the power/volume switch to ON with
low volume
or ON with high volume
or OFF .
• Slide the mode switch to:
Short Play - Plays a short with
a glowing light.
Long Play - Plays approximately
20 minutes of music. Light glows for
about 5 minutes.
• Close the fasteners.
Advertisement
