Philips 42HFL3233D/10 User Manual page 38

PBS settings
[PBS mode]
Enables / disables the Professional mode.
[On]: All settings in the Professional
mode Setup menu are in effect.
[Off]: The TV operates as a normal
(consumer) TV.
[Room ID]
Sets the room ID.
[Channel setup]
A shortcut to enter the channel list, and an option
to change order, rename and hide channels.
[Consumer setup]
A shortcut to enter the full TV menu. This
allows the installers to do all the TV setup
settings.
[USB to TV]
Loads the TV configuration data (including the
video, audio, channel table, and Professional
mode settings) from a USB device to the TV set.
[TV to USB]
Loads the TV configuration data (including the
video, audio, channel Table, and Professional mode
settings) from the TV set to a USB device.
[Reset]
Selects [Yes] to reset all settings in Professional
mode to factory default.
EN
36
Switch on setting
[Switch on channel]
When the guest switches the TV on, it will play at
the specified channel.
[Switch on vol]
When the guest switches the TV on, it will play at
the specified volume level.
[Max volume]
This option specifies the maximum allowable
volume level of the TV.
[Switch on picture format]
Sets available picture format when the TV is
switched on.
Note
•
If the picture format is not supported with the activated
source, [Auto format] detection is applied.
[Power on]
The power on function allows the TV to enter a
specific mode ([On], [ Standby], or [Last status])
of operation after the mains power is activated.
[On]: When set, the TV will always
turn on after the mains power is
activated.
[Standby]: When set, the TV will
always turn to standby after the mains
power is activated.
[Last status]: When set, the TV will
always turn to the last status (either
On or Standby) whenever the mains
power is activated.
[Smart power]
Adjusts the picture backlight to achieve the
following power saving mode.
[Off]: Smart power is disabled.
([Custom] mode is applied).
[On]: Smart power is enabled.