Table of Contents
Advertisement
MOUNTING
2.3 AC Charger Mounting
2.3.1 Mounting the AC Charger
140mm
62mm
3-∅6
Mount the Expansion pipe to the wall once a suitable location has been found.
The AC Charger shall be mounted vertically.
The steps to mount the AC Charger are listed below:
1. According to the cases of the attached installation board, drill 3 x Φ 6 * 35 mm holes
on the wall, and insert the expansion pipe;
2. Lock the 2 x M4*32mm self-tapping screw into the expansion pipe, and reserve 5mm
space;
5mm
05
M4*32 SCREW(*2)
6*30 EXPANASION PIPE(*3)
06
3. Open the top cover of EV-charger, hang it on the 2x M4*32 mm self-tapping screws,
lock it into the bottom M4*32 mm self-tapping screw and then cover the sealing cap;
SEALING CAP
4. Connect wires to the connectors (Refer to Section 3.3), close the upper cover, and
lock it with 2 x M4*12mm screw.
MOUNTING
M4*32 SCREW(*1)
M4*12 SCREW(*2)
Advertisement
Table of Contents
