Advertisement
Overview of parts 1
These are the supplied parts needed to connect
and install this unit.
a In-car audio system
b Sleeve
c Front panel
d Standard ISO connector
e Trim plate
f Rubber cushion
g Disassembly tools
h Screws (4 pieces)
Select country/region
1
Press
to turn on the unit.
2
Rotate
to select an option:
•
[USA] (United States)
•
[Latin] (Latin America)
•
[Europe] (Western Europe)
•
[ASIA] (Asia Pacific)
•
[Mid-East ] (Middle East)
•
[Russia] (Russia)
3
Press
to confirm.
Connection
Caution
•
Ensure that all loose leads are insulated with
electrical tape.
For cars with ISO connectors
234
1
Pull out the ISO connectors from car dash-
board and connect them to the bigger end
of the supplied standard connector.
2
Connect the other end of the supplied stan-
dard connector to the unit.
3
Connect the antenna and amplifier as il-
lustrated, if applicable. You can connect the
car audio to the amplifier through RCA-TO-
RCA cables (not supplied).
Connector
Connect to
1
ANTENNA
Antenna
2
FRONT LINE
Front right speaker
OUT R (Socket)
3
FRONT LINE
Front left speaker
OUT L (Socket)
4
REAR LINE
Rear right speaker
OUT R (Socket)
5
REAR LINE
Rear left speaker
OUT L (Socket)
6
SUBWOOFER
Subwoofer
For cars with ISO connectors
4 5
Caution
•
Be sure to connect the black ground (earth)
lead first.
1
Connect the antenna and amplifier as illus-
trated, if applicable.
2
Cut off the bigger end of the supplied stan-
dard connector.
3
Check the car's wiring carefully and connect
them to the supplied standard connector.
4
Connect the supplied standard connector to
the unit.
1
Green/black strip Left speaker (Rear)
2
White/black strip Left speaker (Front)
3
Gray/black strip
Right speaker (Front)
4
Purple/black strip Right speaker (Rear)
e
RED
Ignition key +12V DC when
ON/ACC
f
BLUE
Motor/electric antenna relay
control lead/Amplifier relay
control lead
g
BLACK
Ground
h
YELLOW To the +12V car battery
which is energized at all times
Advertisement
