Login Procedure - Huawei S2700 Series Quick Start Manual

Configuration Item
Management IP Address
Mask
Old Password
WEB User Password
Confirm Password
WEB User Level
Step 5
Click Apply to save the configuration. When you exit from the initial login page, either of the
following situations will occur depending on the management IP address you configured:
If the management IP address is in the same network segment as 192.168.1.253/24, the system jumps to
the web login page directly.
If the management IP address is not in the same network segment as 192.168.1.253/24, you cannot log in
to the switch again using the web system. You need to configure another IP address for your computer to
make the computer and switch reachable from each other.
The Quick Config function has been added to the web EasyOperation edition since V200R010. You can quickly
finish the configurations of VLAN isolation and interconnection by selecting the Switching and Routing options.
Now, you can log in to the switch using the web system, Telnet, or STelnet to maintain the switch.
9.2 Using the Console Port for the First Login
Before You Start
The S5700-LI, S5700S-LI, S5710-EI, S5720-EI and S5720-HI series switches also support login
through the Mini USB port. For details about this login method, see the
product. This document describes how to log in to the switch through the console port.
In the S5720-EI series, the S5720-50X-EI-AC, S5720-50X-EI-DC, S5720-50X-EI-46S-AC and
S5720-50X-EI-46S-DC models do not have a Mini USB port.
The console cable is not delivered with the switch and needs to be separately purchased if needed.
The display information may differ on different product models.
Install third-party terminal simulation software on the PC by referring to user manual or online
help.

Login Procedure

Step 1 Use a console cable to connect the switch to a PC.
Start the terminal simulation software, create a connection, select a serial port, and set communication
Step 2
parameters in consistent with the default configuration of the switch's console port, as listed below:
Transmission rate: 9600
Data bit (B): 8
Description
Mandatory. Enter the management IP address of the switch, in dotted decimal notation.
Mandatory. Select a subnet mask from the drop-down list box.
Mandatory. Enter the old password for the default web user.
Mandatory. Enter a new password for the default web user.
To ensure password strength, the password must contain at least two types of the following:
lowercase letters, uppercase letters, digits, and special characters (such as ! $ # %), and
cannot contain any space or single quotation mark.
Mandatory. Enter the new password again.
Optional. Select a user level from the drop-down list box. The user of level 3 or higher
has management rights.
10
Configuration Guide of the