Advertisement
Available languages
Available languages
8
Changing the door from the right side to the left.
The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need (Not provided by seller):
8mm socket driver
§
phillips screwdrivers
§
Putty Knife or slotted screwdrivers
§
6mm wrench and 7mm wrench
§
Parts you will need ,parts are from the
package of manual
door stopper
door stop left upper hinge cover
Caution:
To avoid to injury yourself and/or property,
we recommend someone assist you during
the door reversal process.
.Ensure the Appliance is unplugged and empty.
.Following steps are generally recommended
1. Stand the refrigerator, open the upper
door and remove the things in the door and
close it.
2. open the screw hole cove and the upper
hinge cover which is at the top right corner of
the refrigerator.
screw hole cover
3.Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver
or a spanner(please support the upper
door with your hand when doing it ).
right upper hinge part
4.Remove the right upper hinge part and
screw hole cover place them on , the
smooth surface.
OPERATION (CONTINUED)
upper hinge
cover (right)
special flange
self-tapping screws
5.Remove upper door and place it on
smooth surface with panel upwards.
6.Loose screws used to fix middle hinge
and remove middle hinge. Then turn middle
hinge by 180. Take washer on axis and put
it on another end. Place it well for use.
7. Remove lower door and place panel
upwards on smooth surface.
8. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
1
2
1
Lower hinge part (right)
2
Adjustable bottom feet part
9. Use the 8mm socket
driver to remove lower
hinge part and front foot
fixed board. Then Screw
out lower hinge axis and flip over the hinge
body and fix the hinge axis with slotted
screwdriver as the picture shows and mount
washer.
Note: Before this step, you should lay the
refrigerator on it's back in order to gain
access to the base, you should rest it on soft
foam packaging or similar material to avoid
damaging the cooling pipes at the rear of the
refrigerator.
Advertisement
