Table of Contents
Advertisement
Installation
Place the drain hose into your
standpipe, which should have
an
internal
diameter
of
approximately 38mm thus
ensuring there is an air break
between the drain hose and
standpipe.
When discharging into a
standpipe ensure that the top
of the standpipe is no more
than 90 cm (35.4'') and no less
than 60 cm (23.6'') above
floor level.
The drain hose may be
extended to a maximum of 4
metres. An additional drain
hose and joining piece is
available from your local Service Force Centre.
The joining piece must have an internal diam-
eter of 18 mm.
If your drain hose looks like this (see below)
you do not require the "U" piece". Just push
the hose firmly into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any blanking plug
that may be in
place.
Push the drain hose
onto the spigot and
secure with a clip if
required, ensure a
loop is formed in
the drain hose (see
diagram) to prevent
waste from the sink
entering the washing machine.
45
Hide quick links:
Advertisement
Table of Contents
