Specification - Sampo SME-23DL3 Series Service Manual

SPECIFICATION

1. SCOPE
These specifications describe all the characteristics of the 32 inch color monitor.
2. ELECTRICAL REQUIREMENTS
2.1. Cathode ray tube
a. Tube size
b. Dot pitch
c. Light transmission
d. CRT TYPE NAME
2.2. Power
a. Input voltage
b. Input current
c. Inrush current
d. Power consumption
e. Line regulation
f. Stand-by
2.3. Input signal
2.3.1 Video signal
a. Type
b. Polarity
c. Amplitude
d. Input impedance
e. Dot rate
2.3.2 Horizontal sync
a. Type
b. Polarity
c. Input impedance
d. Frequency
2.3.3 Vertical sync
a. Type
b. Polarity
c. Input impedance
d. Frequency
2.3.4 Connector type
2.3.5 Pin assignments for D-SUB connector
Pin 1 : RED
Pin 2 : GREEN
Pin 3 : BLUE
Pin 4 : GND
Pin 5 : GND
32 inch
H = 0.8 mm
35.5% typical
TOSHIBA (M81AHM50X01)
100 ~ 240 Vac , 50 / 60 Hz
2.5 A at 110 Vac / 60 Hz
50 A
220 Watts
95 to 145 Vac / 60 Hz ~ 190 to 255 Vac / 50Hz
less than 10 watts
Analog
Positive
0.714 V
P-P
75 ohms
50M Hz (Max.)
TTL
Positive or Negative
1K ohms
RGB:31 KHz to 48 KHz
AV :15.734 KHz (NTSC) / 60 Hz
15.625 KHz (PAL) / 50 Hz
TTL
Positive or negative
1K ohm (Min.)
50 Hz to 90 Hz
15 pin D-SUB and RCA JACK and S-terminal
Pin 6 : RED GND
Pin 7 : GREEN GND
Pin 8 : BLUE GND
Pin 9 : NC
Pin 10 : GND
- 2- 1-
Pin 11 : GND
Pin 12 : SDA
Pin 13 : H-SYNC
Pin 14 : V-SYNC
Pin 15 : SCL
VER 1.0