Related Manuals for Philips AJ3122/12
Summary of Contents for Philips AJ3122/12
- Page 1 Clock Radio AJ3122 Register your product and get support at www.philips.com/welcome User manual...
-
Page 3: Alarm Reset
Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS (see fig. 1 ) 1 SET TIME /ALARM SET – sets the clock time – sets the alarm time 2 HR / MIN –... -
Page 4: Installation
POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. -
Page 5: Radio
You can use this set solely as a radio! 1 Adjust RADIO / ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the FM/MW switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. -
Page 6: Switching Off The Alarm
SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER. -
Page 7: Repeat Alarm
This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT 2 Repeat if desired for up to 59 minutes. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. -
Page 8: Safety Information
• Install the unit near the AC outlet and where the AC power cord plug can be easily reached. • Where the MAINS plug or an appliance coupler is used as the discon- nect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. -
Page 9: Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. -
Page 10: Environmental Information
ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. -
Page 11: Class 1 Laser Product
Meet Philips at the Internet http://www.philips.com AJ3122 CLASS 1 LASER PRODUCT Printed in China AJ3122_12_UM_V2.0...
Need help?
Do you have a question about the AJ3122/12 and is the answer not in the manual?
Questions and answers
Not on radio
The Philips AJ3122/12 radio may not be working due to the following possible causes:
1. Volume not adjusted – Adjust the volume.
2. Weak FM signal – Adjust the position of the pigtail antenna.
3. Electrical interference during MW broadcast – Move the radio away from other electrical equipment.
4. Alarm not functioning – Set the alarm time and select the alarm mode; adjust volume if too low; tune to a radio station if using radio alarm.
5. Power issues – Ensure the unit is plugged in and power is accessible.
Do not attempt to repair the set yourself, as this will invalidate the warranty and may cause electric shock.
This answer is automatically generated