Page 3
CONTROLS (see fig. 1 ) 1 SET TIME /ALARM SET - sets the clock time - sets the alarm time 2 HR / MIN - adjusts the hours / minutes for clock / alarm / sleep time 3 REPEAT ALARM / SLEEP OFF - switches off the active alarm for a 9 minutes period - switches off the radio sleep function 4 ALARM RESET...
Page 4
Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. 3 Refit the fuse cover.
Page 5
INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bot- tom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet.
RADIO You can use this set solely as a radio! 1 Adjust RADIO / ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the FM/MW switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level.
SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two dif- ferent alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER.
REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM. 2 Repeat if desired for up to 59 minutes. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time.
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC power cord plug can be easily reached. • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable. •...
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a special- ized company. Please observe local regulations on the disposal of packing materi- als and old equipment.
Page 12
Meet Philips at the Internet http://www.philips.com AJ3121 Printed in China PDCC-Jason-0716...