Dc Power Supply / Volt Meter Product Set-Up - X-Tronic 8080 Instructions Manual

3. Never point the hot air gun towards any flammable material or
human skin. There is very hot air exiting the outlet that may cause
serious burns or damage.
4. Do not use pliers or any other tool to manipulate hot air nozzles.
5. Do not try to reform nozzle attachments into other shapes.
Product Set Up
1. DC Power Supply
a. Ensure all connections are secure and fuse in the rear of unit is
in good working order before applying power
b. Plug in power cord to a GROUNDED AC wall outlet
c. Select Output Display using Output/Test Voltage Selection
Switch
d. Select proper A/mA, using A/mA selection Switch, to be used
e. Attach proper output connectors to output terminals
f. Ensure all output connections are secure
g. Ensure all adjustment knobs are turned counter clockwise
before powering on unit for first time
h. Power on unit
i. Use Adjustment Knobs to set desired Voltage/Current
2. Voltmeter
a. Ensure all connections are secure and fuse in the rear of unit is
in good working order before applying power
b. Plug in power cord to a GROUNDED AC wall outlet
c. Select Test Voltage using Output/Test Voltage Selection Switch
d. Select proper A/mA, using A/mA selection Switch, to be used
e. Attach proper output connectors to test input terminals
f. Ensure all input connections are secure
g. Continue to probe desired points for unknown voltage
DC Power Supply & Voltmeter
- 7 -