Table of Contents
Advertisement
16. Replace the tip over the heating element.
17. Replace the outer metallic shaft of the soldering iron.
18. Replace the metallic nut and tighten.
Hot Air Gun
1. Turn off the unit and unplug it from the power source.
2. Allow the unit to reach room temperature before proceeding.
3. Remove any attachments that are on the hot air gun.
4. Remove the 3 screws on the hot air gun.
5. Slide the silicone tubing off of the hot air gun.
6. Pull the two halves of the hot air gun apart (they are glued together).
7. Slide the metallic shaft off of the heating element.
8. Remove the fiberglass paper from the heating element.
9. De-solder the broken heating element, paying special attention to
wire color and placement.
10. Solder the new heating element leads in the correct places.
11. Wrap the new heating element in mica paper.
12. Slide the metallic shaft over the heating element and place it back
into the hot air gun. Line up the holes with the standoff present in
the gun.
13. Put the two sides of the hot air gun back together, lining up with the
holes on the metallic shaft.
14. Reinsert the 3 screws and tighten them.
15. Reattach the silicone hose.
- 12 -
Advertisement
Table of Contents
