Safety Instructions - DURAVIT SensoWash Starck f Mounting Instructions

About the mounting instructions
These mounting instructions come as part of the Duravit
product and should be read carefully prior to installation.
Target readership and qualifications
The product and associated water connection should only be
installed by qualified plumbers. The electrical installation
should only be carried out by qualified electricians.
Explanation of the signal words and symbols
DANGER
WARNING
CAUTION
NOTICE
Link to the Electrical Installation section
Link to the installation information in this section
Link to other instructions
Link to the Water Installation section
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks and leak-tightness
4
57363_Mounting_SeWa_Starckf_WWC_US/20.06.1
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
Indicates a hazardous situation which,
if not avoided, could result in death or
serious injury.
Indicates a hazardous situation which,
if not avoided, could result in minor
or moderate injury.
Is used to address practices not
related to physical injury.

Safety Instructions

Risk of fatal electric shock!
> Disconnect electrical components from the power supply
before the installation.
> Prevent the power supply from being switched on
accidentally by third parties.
> Connect the product only to the specified power supply.
> NEVER touch the power supply cable with wet hands.
> When working on electric components, disconnect the power
supply.
Product and/or property damage
> Do NOT install the product in a room exposed to excessive
moisture. Ensure sufficient ventilation to avoid condensation
in electric components.
> Only use the parts in the installation kit to avoid
malfunctions.
> Do NOT use attachments not recommended by Duravit.
Freezing water
If the room temperature is too low, this can cause damage to
the product.
> Do NOT install the product in rooms where there is a danger
of frost. The room temperature must not be less than
4 °C (39 °F).
Standards and regulations
The breach of local and country-specific regulations and
standards can cause damage to the product and/or property
damage.
> Local installation regulations, country-specific standards
and the Low Voltage Directives shall be observed at all times.
Mounting instructions
Please read the pre-installation information sheets prior to the
installation. These are available to download on the Internet at
www.pro.duravit.com.
These mounting instructions for the Starck f wall-mounted WC
describe the exposed electrical connection with plug. Concealed
connection is also possible.
- Order connection box # 100745 0000
- Follow the instructions enclosed
2
Installation with DuraSystem
The water connection to the SensoWash
be made via a permanent connection or via ductwork in
the cistern (generally for DuraSystem
#WD1009, #WD1007, #WD1005)
> Use an additional mounting set, see www.pro.duravit.com.
3
Installing the noise reduction gasket
> If the noise reduction gasket is included in the delivery,
the z thickness must also be taken into consideration:
z + 50 mm (2 ").
> Install the noise reduction gasket.
16
Storing the mounting accessories
> Store the accessories for installing the shower toilet
unit in a safe place.
®
shower toilet can
®
except #WD1010,
®