Seat Sound System 1.0 Owner's Manual page 12

Adjusting the base volume
Function Meaning
Increase the vol- Turn the volume control  clockwise
ume. or press the

wheel.
Lower the volume. Turn the volume control  anti-clockwise
or press the

wheel.
At 0 the unit is muted (display: ) and any media source currently being
played will be stopped.
Changes to the volume are indicated by a bar on the screen.
It is possible to preset certain volume settings and adjustments
⇒ p age 28.
CAUTION
If the volume is too high or the sound is distorted, the vehicle speakers may
be damaged.
Note
If the base volume has been considerably increased on the radio system to
play a certain audio source (e.g. due to very quiet audio output from an ex-
ternal audio source), lower the volume again before switching audio source.
button on the multifunction steering
button on the multifunction steering
Names of controls
Overview
● Rotary/push knobs
● Labelled unit buttons (hard keys).
● Function buttons (soft keys).
Rotary/push knobs
The left-hand rotary/push knob
trol  or the on/off switch.
The right-hand rotary/push knob
knob.
Unit buttons and function buttons
The system labelled buttons are called "unit buttons", e.g.
There are six unlabelled unit buttons below the screen
unit buttons are referred to as "function buttons" as their functions change
depending on the current operating state.
The current function of a function button is displayed just above the button
in the bottom line of the screen (e.g.

Introduction
⇒ f ig. 1
is referred to as the volume con-
1
⇒ f ig. 1
is referred to as the setting
8
button.
RADIO
⇒ f ig. 1
. These
11
⇒ f ig.
6).
11
