Preparing To Use The Detector - Canon AX-B2735W Manual

4
Operating procedures
4.1

Preparing to use the detector

1
Charge the battery pack.
Charge the battery on the day of examination or on the previous day. Charge the
battery pack by inserting in the battery charger.
Battery slowly discharges even if not in use. The battery pack may have expired
if it discharges immediately after being fully charged. You can purchase an
optional battery pack to replace an exhausted one.
2
Attach the battery pack.
Place the detector on a flat surface before commencing the steps below.
Otherwise the battery pack may fall out while it is being attached.
i)
• Press and hold the battery cover lock (
the battery cover (
Do not lift the cover more than approximately 60° while the claws are inserted
in the grooves.
30
Information
Information
Remove the battery cover.
).
Cover lock
Information
) to release the lock, then lift up and pull out
Battery cover
Claws