Table of Contents
Advertisement
3.3
Ready indicator
The ready indicator is connected to the image-capture computer via USB and is attached
using the hook-and-loop fastener in a place where it can be easily seen.
The LED lamps on the detector light up when the detector is in exposure ready status.
As the available image-capturing time (maximum 10 minutes) after the detector is changed
to exposure ready status, is reduced to 5 minutes remaining, 1 minute remaining and 10
seconds remaining, or when the X-rays are received by the detector, the detector beeps,
or the LED lamps on the detector light up or flash. The volume can be controlled or set to
mute.
This unit is used as an interface of the image-capture computer for infrared
communication with the detector, which registers the detector to the laptop computer.
Important
Do not install the ready indicator such a position that its IR data port faces the monitor,
reflector, or other IR data communication equipment, except for the detector.
A
Mute switch
B
LED status indicator
C
IR data port
D
Volume button
E
Speaker
F
Micro USB connector
G
Micro USB cable
A
B
C
D
Slide to
disable the mute function.
Lights up or flashes to indicate detector status, detector
registration, and connection status.
Communication port for the detector link (registration/
connection)
Click
volume.
A beeping sound is emitted from the speaker openings.
Connector for the micro USB cable (Micro B type)
Connect to the image-capture computer.
3
E
F
G
to enable the mute function, and to
to turn up the volume, and
Parts names and functions
to
to turn down the
27
Advertisement
Table of Contents
