Install Remote Control Battery - Philips PD7060/05 User Manual

Philips portable dvd player pd7060 17.8 cm (7") digital panel 6-hr playtime
Hide thumbs Also See for PD7060/05:
Table of Contents

Advertisement

The charge indicator turns on. When the player is not in use, it will
»
take about 8 hours to fully charge it. However, when in use, it will
take more than 16 hours to fully charge it.
When the battery is fully charged, the charge indicator turns off.
»

Install remote control battery

Caution
Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard
batteries in fire.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Batteries contain chemical substances, they should be disposed of properly.
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
For first-time use:
1
Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
3
Close the battery compartment.
EN
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pd7060

Table of Contents