Table of Contents
Advertisement
3.
Leave the product in its original packing box until it is ready for installation.
4.
If pallets are stored outside temporarily, a protective covering over the pallet should be placed to protect products
from direct weathering. Pallets should not be stacked more than one pallet high.
5.
At the installation site, keep modules and electrical contacts clean and dry before installation.
6.
Do not stack more than the maximum amount of allowable pallets on top of each other. Do not exceed two layers
of pallets high.
7.
Do not place modules directly on top of each other.
8.
Do not place excessive loads on the module or twist the module frame.
9.
Do not stand, step, walk and/or jump on the module.
10.
Do not carry a module by its wires or junction box but by its frame with both hands by two or more persons.
11.
Do not mark the module with a sharp instrument.
3
|
SAFETY INFORMATION
The instructions in this safety manual are intended to prevent danger, damage, and failure.
DO NOT touch electrically active parts of the panel, such as the output wiring, without the adequate safety protection.
Bare contact may cause an arc or shock that can lead to injury or even death. Do not use a module that is broken, torn,
or damaged. Non-conformity may cause damage, failure, and/or serious bodily injury.
1. Before installing a system, contact the appropriate authorities for site installation, inspection permission/s
and requirement/s.
2. Operators shall foresee the risk of injury during the processes of installation, troubleshooting and maintenance
of the modules. Therefore, only authorized, and trained personnel should have access to, and perform work
on the modules or system.
3. Ensure that modules meet the technical requirements of the system as a whole.
4. When connecting the modules, remove all metallic jewelry, use properly insulated tools, and wear appropriate
personal protective equipment to reduce the risk of electrical injury.
5. Do not disassemble the modules or remove any part of the module.
6. Do not stand, step on, damage, or scratch surfaces of the module.
03
Advertisement
Table of Contents
