Manual Overview; Disclaimer Of Liability; Declaration; Unpacking And Storage Information - boviet SOLAR GAMMA Series Installation And Maintenance Manual

Table of Contents

MANUAL OVERVIEW

This manual offers general information regarding installation and maintenance of photovoltaic

modules manufactured by Boviet Solar, which thereafter will be referred to as "modules."

These manual instructions should be read and understood before installation, handling, or

maintenance. To ensure the correct and safe use of the photovoltaic modules, the installer

should be familiar with the mechanical and electrical requirements for photovoltaic systems.

The installation, handling and use of modules are beyond Boviet's control, and Boviet Solar does

not assume responsibility for loss, damage, injury, or expense resulting from the improper installation,

handling, use, or maintenance of the module.

Boviet Solar assumes no responsibility for any infringement of patents or other rights of the third parties that may

result from use of the module. No license is granted by implication or under any patents or patent rights.

Boviet Solar reserves the right to update this manual, module specifications and/or relevant information

without prior notice.

The fire rating of the module is valid only when mounted in the manner specified in the mechanical

mounting instructions.

The module is considered in compliance with UL 1703/61730 or IEC 61215/61730 only when mounted in the manner

specified in the mechanical mounting instructions below.

A module with exposed conductive parts is considered to be in compliance with UL 1703/61730 or IEC 61215/61730

only when it is electrically in accordance with the instructions presented below and the National Electrical Code.

Any module without a frame (laminator) should not be considered to comply with the requirements of UL 1703

or IEC 61215/61730 unless the module is mounted with hardware that has been tested and evaluated with the

module under this standard or by a field engineer certifying that the installed module complies with the requirements

of UL 1703/61730 or IEC 61215/61730.

At the time of receipt, verify that the product delivered is the same product ordered. The product name, sub name,

and serial number of each module are clearly marked on the outside of each packing box.

Store packing boxes in a dry and ventilated room.

Table of Contents