Advertisement
WARNING!
result in serious injury to the operator.
Do not use a deformed or cracked blade. Replace it with a new one.
Draw a guideline along the desired line of cut before operating.
Refer the specific safety warnings provided at page no. 6 & 7
before operating the machine.
Do not attempt to cut wood or masonry with this machine. Never
cut magnesium or magnesium alloy with this tool.
Secure the tool in a place to prevent machine movement during
the cutting procedure. Firmly secure the material to be cut using
the machine's vice.
Start the machine by fully depressing the trigger switch and allow
the cut-off wheel to come up to full speed before contacting
wheel to material.
Slowly push down on the machine arm handle until the cut-off
wheel contacts the material being cut. Use a steady and even
pressure to obtain a uniform cut. Never force the wheel into the
material.
When the cut is completed, release the trigger switch and allow
the wheel to stop before raising it to the full open position.
Large, circular, or irregularly
shaped material may require
additional means of clamping to
be secured in place adequately
for cutting. Use C-clamps or
blocks (as shown in the figure) to
hold material securely.
Do not touch the cut material
until it cools or you will be
burned.
Always switch the product off, disconnect the product from the
NOTE:
power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
GENERAL OPERATION
Never twist or force the tool in the cut. This may
16
IBL CM35-24
Advertisement
