Flintec CC1W Installation Manual

CC1W
Installation
Guide
Follow this guide to ensure the system is
properly installed and performing as intended.
Use the indicator lights to check performance,
making adjustments as needed.
Contact support hotline for advice.
INSTALLATION SUPPORT HOTLINE: (978) 333-7539
1 Mount the base
unit and antenna
3
Mount the
load cell and
rotate toward
base unit
5
Connect
the wires
power
signal
flintec.com
2 Position the
antenna
4 Install the
battery
6
black Ground
yellow Shield
red 12 - 24VDC
Comms indicator
Data is being
red Vref+
transfered
green Sig+
(Blue /
white Sig-
black Vref- red flashes)
yellow Shield
grey Position+
violet Position-
0099980 v1.0
Note
Mount the base unit in or near
the control box.
Secure the antenna as high as
possible by utilizing the
extension cable.
Orientate the antenna's horizontal
edge to face the load cell.
Maintain line-of-sight, if possible.
Note
Mount the load cell, top plate and
washer set as recommended.
Position the front of the load cell
(Flintec logo) toward the base
unit.
Connect battery and seal the
door.
Use the indicator lights to verify
the system is working properly
Link quality
indicator
Good signal (Off)
Poor signal (Yellow)
No signal (Red)
Power indicator
Both transceivers
have power (Red)