Citizen CBM-262 User Manual page 104

Chapter 7 Print Control Codes
• When the first character at the head of a line is developed, if the print area width is
too small for the horizontal width of the character you are attempting to develop
(including the right space), the following processing is carried out for that line
only.
(1) The printer enlarges the print area to the right to a size where that character can
(2) If a sufficient amount of space still cannot be secured by the processing in (1),
(3) If a sufficient amount of space still cannot be secured by the processing in (2),
• When developing a bit image (or a downloaded bit image), if the print area width
does not fill the bit image's minimum horizontal width (2 dots for single density, 1
7
dot for double density), the following processing is carried out for that line only.
(1) The print area is enlarged to the right until it is equal to the minimum horizon-
(2) If a sufficient amount of space still cannot be secured by the processing in 1,
• The initial value is "n1 = B0", "n2 = 1".
94
fit as long as it doesn't exceed the printable area.
Printable Area
Left Margin
Print Area Width
the print area is enlarged to the left (the left margin is reduced).
Printable Area
Left Margin
The left margin
the right space is erased.
tal width of the bit image, as long as it doesn't exceed the printable area.
the print area is enlarged to the left (the left margin is reduced).
Enlarged to the right
is erased.
Print area width
Enlarged to the right.