Table of Contents
Advertisement
Personalization
Acoustic signals
The machine is provided of an acoustic device,
which sounds in the following cases:
at the end of the cycle
●
in the event of operating problems
●
By pressing the «Prewash» and «Stain» buttons simultaneously for about 6
seconds, the acoustic signal is deactivated (except for the events of operating
problems). By pressing these 2 buttons again, the the acoustic signal is
reactivated.
Daily Use
Load the laundry
1. Open the door by carefully pulling the door
handle outwards. Place the laundry in the drum,
one item at a time, shaking them out as much
as possible.
2. Close firmly the door. You must hear a click
during closing.
Attention! Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce
water, energy and detergent consumption.
1. Pull out the dispenser drawer until it
stops. Measure out the amount of
detergent required, pour it into the main
wash compartment
to carry out the prewash phase or to
perform the stain function , pour it into
the compartment marked
and, if you wish
.
Use
11
Advertisement
Table of Contents
