Table of Contents
Advertisement
10
Personalization
The display says to press the button 5 to confirm the language and then the button 4 to
change the selection.
Press the button 5 twice to confirm your choice.
Setting the time
After the desired language you must set the time before the first wash. Remember to change
the setting time in accordance with daylight-savings time or solar time.
The CLOCK setting permits you to modify/set up the current time. It is important to keep
it updated as the current END Cycle Time depends on it.
To set the time press repeatedly the button 4 to select the settings menu (SETTINGS) and
confirm your choice by pressing button 5 .
With a single and short pressing of the button 4 , the hours can be adjusted.
Press the button 5 to confirm it. Repeat the previous operation for setting the minutes.
If the appliance has already been switched on once, refer to the beginning of «Personali-
zation» chapter.
Personalization
This appliance is provided with a settings menu that allows you to modify the factory
settings as you want.
When you switch on the machine, by turning the programme selector dial, press the button
4 to activate the options menu. By pressing again the same button you can move through
all the available options till when you locate the settings menu. Press the button 5 to access
in the menu. Use the button 4 again to scroll all the settings and press button 5 to confirm
your choice.
Setting the brightness
The brightness setting (BRIGHTNESS) allows you to modify the backlight intensity of the
display.
By pressing the button 4 , you can increase or decrease the brightness.
You can choose between different levels from 0 to 9 (0 = min. - 9 = max.).
Press button 5 to confirm your choice.
Setting the contrast
The contrast setting (CONTRAST) allows you to modify the optical characteristic of the
display.
By pressing the button 4 you can increase or decrease the contrast.
You can choose between different levels from 0 to 9 (0 = min. - 9 = max.).
Press button 5 to confirm your choice.
Setting the acoustic signal
The machine is provided with an acoustic device, which sounds in the following cases:
• at the end of the programme
• in the event of operating problems
Advertisement
Table of Contents
