Mm371W, Mm372W, Ts571W Battery Enclosure Kit Setup; Control Box - Battery Enclosure Kit Connection - Mighty Mule MMB200 Installation Instructions Manual

MM371W, MM372W, TS571W BATTERY ENCLOSURE KIT SETUP

Control Box – Battery Enclosure Kit Connection
1.
In order to install the Battery Kit, you'll need to provide wiring access from the Control Box to the Battery Enclosure Kit .
With a drill and 1/2" drill bit, drill out the plug designated for Battery Power Access .
2.
Connect the battery harness to the battery as shown: red to positive, black to negative terminals .
3.
Place the battery into the right side of the Battery Enclosure Kit with the terminals facing to the right and towards the
top of the Battery Enclosure Kit .
Control Box
RESET
TERM6
BAT+
BAT–
SW1
SW2
LOCK
Battery Power Access
17
1 2 3 4 5
AUTO
CLOSE
+ –
AUX