Mm272 Installation Preparation; Mm272 Battery Installation - Mighty Mule MMB200 Installation Instructions Manual

MM272 INSTALLATION PREPARATION

Feed the Control Box end of Battery Harness A through the Strain Relief fitting as displayed above .

MM272 BATTERY INSTALLATION

This section covers battery installation for the MM272 . However, this set of instructions for a separate Control Box installation
can also be used for MM371W, MM372W and TS571W installations . See MM371W, MM372W, TS571W Battery Enclosure Kit
Setup, page 17, for instructions on the preferred method for MM371W, MM372W and TS571W installations .
To complete construction of the required harness, connect Battery Harness A to Battery Harness B (refer to the diagrams on
this page) .
NOTE: Either end of the newly constructed Battery Harness may be connected to the first battery . The opposite battery
connection is available for a second battery .
Connect to Red +
Battery 1
Black –
Red+
Black–
Black–
Red+
Red +
Red +
Black –
Black –
Battery Harness B
13
Red+
Black–
Connect to
Control Box
Red +
Battery Harness A
Black –
Red +
Connect to
Battery 2
Black –
Connect to
Battery Harness B
Connect to
Control Box