Table of Contents
Advertisement
Never connect HD PowerSmoke
!
Never connect HD PowerSmoke
!
3. CONNECT TO AIR SUPPLY
a. Connect compressed air supply to Air Inlet.
*Replace quick coupler fitting if necessary. 1/4 in. NPT male.
4. Adjust HD PowerSmoke
a. Turn Flow Control Valve off.
b. Set desired Test Pressure. (PULL to unlock, TURN to adjust pressure, PUSH to lock)
c. Attach Vapor Hose to installed adaptor of system being tested.
d. Depress the Vapor Test Switch (#5) button to begin 15-minute vapor test cycle.
e. Turn Flow Control Valve to release pressure / vapor.
f. Use halogen inspection light provided to inspect for leaks.
1.FILL / ADD VAPOR PRODUCING FLUID
a. Remove fluid fill plug with hex key.
b. Pour OEM-Approved Vapor Producing Fluid into fluid
fill port.
c. Fill fluid fill port until fluid level is near top of port.
d. Replace fluid fill plug.
!
2. CONNECT TO POWER
•
Use the power selector switch on rear of machine to
select input power, AC or DC.
•
If 12 Volt DC is preferred, connect the battery cables to
a fully charged 12 Volt battery. RED to positive, BLACK
to chassis ground.
•
If AC power is preferred, connect a properly rated
power cord into the AC Power Port.
•
Green Power Indicator lamp illuminates with proper
power hook up and power source selected.
to a battery charger or jumper box.
™
to vehicle with engine running.
™
for testing
™
2 fl. oz. (60 ml) maximum to refill when empty
SET UP
5
Advertisement
Table of Contents
