Safety - Redline HD PowerSmoke Operation Manual

HD PowerSmoke is designed to be used in conjunction with the supplied Power INTAKE
™
threaded sensor port adapters, also provided is a cooling system adapter to test the intake, exhaust, and
cooling systems of boosted engines.
DO NOT USE IN EVAP SYSTEM
!
HD PowerSmoke utilizes higher test pressure that may damage components in evaporative emission
™
systems. Redline Detection manufactures OEM approved EVAP leak detectors such as, Smoke Pro
Total-Tech [95-0003/B] and Smoke Pro Air Complete
®
system and general repair diagnostics.
SAFETY TIPS
• All diagnostic work should be performed with the engine off
• For use only by professional technicians
• Ensure that the vehicle is secure and stable
• Exercise caution when connecting and disconnecting compressed shop air supply
• Do not leave a vehicle unattended while equipment is operating
• Always wear proper safety protection
• This safety guide is not intended to take the place of common sense and good judgment
Power INTAKE Adapters Safety:
™
• The maximum test pressure a Power INTAKE
• Slippage of a Power INTAKE
Intake / Exhaust system, coefficient of friction, internal pressure of the Power INTAKE
the accuracy of inflation instruments.
• Generally, a Power INTAKE
slipping when test pressure exceeds 50% of the internal inflation pressure. Inflation pressure and back
pressure limitations are subject to temperature / humidity change.
• Power INTAKE Adapters should NEVER be inflated over 1.6 times its outside diameter.
™
• Debris, protrusions and residue in the Intake / Exhaust system could weaken and / or rupture the bladder
of the Power INTAKE
™
Redline Detection shall not be responsible for any incidental or consequential damages.
• Power INTAKE Adapters must be mechanically anchored with the provided chain / cable to a secure
™
anchor before use.
• Power INTAKE Adapters slippage under test pressures may cause property damage or injury.
™
• NEVER use inflation pressure with Power INTAKE
capacity of the weakest component in the system under test.
• NEVER use Power INTAKE
• Before use: Refer to Power INTAKE
limitations and tether restraint installation instructions.
Adapters may restrain can only be estimated.
™
Adapters is influenced by many factors including debris / residue in the
™
Adapters properly inserted into an Intake / Exhaust system may begin
™
Adapters. Bladder failures due to misuse or abuse are not covered by warranty.
Adapters when its failure could cause injury or catastrophic damage.
™
Adapters Installation and Inflation procedures, back pressure
™
[95-0051] which are specifically designed for EVAP
™
Adapters or a test pressure that is greater than the
™

SAFETY

Adapters, or
™
®
Adapters, and
™
3