Page 4
INSTALLATION INSTRUCTION BM 61 T09218 Tip Protection WARNING: Tip Protection bars must be installed whenever the Booklet Maker is used together with Belt Stacker and Base. Before mounting the Booklet Maker on Base, secure the Tip Protection bars to the Base with screws 99237.
Page 5
Fit the green adhesive tape 1 on the outfeed paper guide on the Collator and align it with the green arrow on the rear jogger. When setting up the BM 61 to A4 (8.5” x 11”) the green tape 1 should be aligned with the green arrow on the rear side jogger.
Page 6
Aligning with Friction Feed Collator, continued Washer 97041 (4x) NOTE: When installing the BM 61 to the Collator, check (1) the level of the paper path between machines. If the paper path on the Collator is too low, place the washers (4 pcs) 97041 between...
Page 8
INSTALLATION INSTRUCTION BM 61 T09218 Changing speed on Collator Description Note Procedure Switch main power on. 2 Enter program The button doesn’t Press button (A) and hold until all green mode. show on panel. Button LEDs on front go out.
Need help?
Do you have a question about the BM 61 and is the answer not in the manual?
Questions and answers