Advertisement
Installing the ERM in a rack
Before installing the unit, review and adhere to all warnings
provided in "Precautions."
WARNING: To reduce the risk of personal injury or
damage to the equipment, be sure that:
•
The leveling feet are extended to the floor.
The full weight of the rack rests on the leveling feet.
•
•
The stabilizing feet are attached to the rack if it is a
single-rack installation.
•
The racks are coupled together in multiple-rack
installations.
Only one component is extended at a time. A rack
•
may become unstable if more than one component is
extended for any reason.
NOTE: Mounting hardware for square- and round-holed
racks is included in the UPS kit.
1.
Attach the 2U side-mounting brackets to the unit.
2.
Loosen the wing nuts, and extend the brackets to the desired
length.
3.
Insert screws through the rack into the mounting rail and the
front of each mounting bracket. Do not tighten.
4.
Insert screws through the rack into the mounting rail and the
rear of each mounting bracket. Do not tighten.
5.
Tighten the wing nuts.
6.
Wait until the unit is installed and the brackets are adjusted
before tightening the screws.
WARNING: Uneven mechanical loading in the rack may
cause a hazardous condition
CAUTION: Always plan the rack installation so that the
heaviest item is on the bottom of the rack. Install the
heaviest item first, and continue to populate the rack from
the bottom to the top.
7.
With one person on each side, lift the chassis to rail level and
slide the chassis on the mounting rails.
8.
Attach the chassis to the rack using the supplied screws.
Advertisement
