Panasonic NV-DS29EG Manual page 63

Note:
Install Camera Connecting Cable so that the Connector is upward
as shown.
3. Connect the Camera Connecting Cable to the Connector B2 on
the Main C.B.A.
4. Connect the AC Adaptor to the unit.
5. Connect the DC Output Cable (and AC Adaptor) to the J101 on the
Measuring Board.
6. Connect the J102 on the Measuring Board to RS232C of the PC
with 232C (M3) I/F Cable.
7. Set the SW101 (RS232C SEL) on the Interface Board to "M3."
8. Set the SW102 (FLUSH1) on the Interface Board to "NORMAL."
9. Set the SW103 (VTR TEST) on the Interface Board to "L."
10. Set the SW104 (BST TEST) on the Interface Board to "NORMAL."
11. Set the SW105 on the Interface Board to "L."
Fig. E1-3
63