High/Low Beam Switch; Automatic High Beam Headlamp Control - If Equipped - Dodge RAM 1500 2019 User Manual

High/Low Beam Switch

Push the multifunction lever toward the in-
strument panel to switch the headlights to
high beam. Pulling the multifunction lever
back toward the steering wheel will turn the
low beams back on, or shut the high beams
off.
Automatic High Beam Headlamp
Control — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control
through the use of a digital camera mounted
on the inside rearview mirror. This camera
detects vehicle specific light and automati-
cally switches from high beams to low beams
until the approaching vehicle is out of view.
NOTE:
• The Automatic High Beam Headlamp Con-
trol can be turned on or off by selecting
"ON" under "Auto Dim High Beams"
within your Uconnect settings, as well as
30
turning the headlight switch to the AUTO
position. Refer to "Uconnect Settings" in
"Multimedia" in the Owner's Manual for
further information.
• Broken, muddy, or obstructed headlights
and taillights of vehicles in the field of view
will cause headlights to remain on longer
(closer to the vehicle). Also, dirt, film, and
other obstructions on the windshield or
camera lens will cause the system to func-
tion improperly.
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the
mirror must be re-aimed to ensure proper
performance. See a local authorized dealer.
To Activate
1. The Automatic High Beams are enabled
through the Uconnect system. Refer to
"Uconnect Settings" in "Multimedia" in
your Owner's Manual
information.
2. Turn the headlight switch to the AUTO
headlight position.
3. Push the multifunction lever away from
you (toward front of vehicle) to engage the
high beam mode.
NOTE:
The Automatic High Beams will not activate
until the vehicle is at or above 12 mph
(20 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deacti-
vate the system (normal operation of low
beams).
2. Push back on the multifunction lever to
reactivate the system.
The Automatic High Beams can also be de-
activated through the Uconnect system. Re-
fer to "Uconnect Settings" in "Multimedia"
in the Owner's Manual for further informa-
tion.
for further