Flash-To-Pass; Automatic Headlights - If Equipped; Parking Lights And Panel Lights; Headlights On With Wipers (Available With Automatic Headlights Only) - Dodge RAM 1500 2019 User Manual

Flash-To-Pass

You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the high
beam headlights to turn on, and remain on,
until the lever is released.
Automatic Headlights — If
Equipped
This system automatically turns the head-
lights on or off according to ambient light
levels. To turn the system on, rotate the
headlight switch counterclockwise to the
AUTO position. When the system is on, the
headlight time delay feature is also on. This
means the headlights will stay on for up to
90 seconds after you place the ignition into
the OFF position. The headlight time delay
can be programmed 0/30/60/90 seconds.
Refer to "Uconnect Settings" in "Multime-
dia" in the Owner's Manual for further infor-
mation.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will turn on in the Automatic Mode.

Parking Lights And Panel Lights

To turn on the parking lights and instrument
panel lights, rotate the headlight switch
clockwise. To turn off the parking lights,
rotate the headlight switch back to the O (off)
position.
Headlights On With Wipers
(Available With Automatic
Headlights Only)
When this feature is active, the headlights
will turn on approximately 10 seconds after
the wipers are turned on if the headlight
switch is placed in the AUTO position. In
addition, the headlights will turn off when the
wipers are turned off, if they were turned on
by this feature.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to "Uconnect Set-
tings" in "Multimedia" in the Owner's
Manual for further information.

Headlight Delay

To aid in your exit, your vehicle is equipped
with a headlight delay that will leave the
headlights on for approximately up to 90 sec-
onds. This delay is initiated when the ignition
is turned off while the headlight switch is on,
and then the headlight switch is cycled off.
Headlight delay can be canceled by either
turning the headlight switch on then off, or by
turning the ignition to the ON/RUN position.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to "Uconnect Set-
tings" in "Multimedia" in your Owner's
Manual for further information.
Fog Lights — If Equipped
The fog lights are turned on by rotating the
headlight switch to the parking light or head-
light position and pushing in the headlight
rotary control.
The fog lights will operate only when the
parking lights are on or when the vehicle
headlights are on low beam. An indicator
light located in the instrument cluster display
31