Kalorik TKG VT 1021 Manual page 7

ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and protection grid.
1. Insert the rear grid (5) onto the motor shaft, so that the handle
is at the top (like in the figure to the side), securing it using
the 4 screws provided (4.)
2. Insert fan (2) onto the motor shaft (6) and attach it so that
the screw (3) touches the milling formed on the motor shaft
(like in the figure), (at the end of the work, check that the
fan is correctly secured).
3. Couple the front grid (1) with the rear grid (5) and lock with
the retention hooks. For safety reasons, you must ensure the
fastening with the appropriate locking screw (12) in the
holes provided on the edge of the grid, (the screw holes
must be in the lower part).
USE
Ventilation: select the desired speed by turning the switch to one of the following
positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button located on the motor body.
To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in
the direction desired; tighten the screw (9) to lock the motor housing in the desired
position.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
•
Before normal cleaning, remove the plug from the socket.
•
Clean the body with soft slightly damp, cloth; do not use abrasive or corrosive products.
•
Do not immerse any part of the fan in water or other liquid
•
Use a vacuum cleaner to remove from dust and lint from the motor's air holes.
•
If the fan will not be used for long periods, it must be protected from dust and humidity.
7 TKG VT 1021