Advertisement
Installation mode 1 (permanent)
For permanent installation, mark the two
holes for either "L" or "R" installation with
the card. Replace the card with the
mounting bracket, and screw into place.
The mounting bracket can be installed this
way either by its side or flat.
Fitting blind adjustment chain to device
Open the device backing by pushing gently inwards to release.
Determine the suitable gear from the below diagram, and attach this to the device.
Fix the blind adjustment chain to the gear, and close the device backing.
2mm 4mm 6mm
4
4.5x6mm 4.5x12mm metal chain
Installation mode 2 (no holes, removable)
For a removable installation, use supplied
3M adhesive to fix to wall. It is
recommended to leave the mounting
bracket to set on the wall for at least 12
hours before applying the full weight of the
attached device.
beaded chain 3.2mm
Advertisement
