System Controller - Briggs & Stratton ComAp InteliLite NT Manual

System Controller

R
P
N
M
L
Position Button
A Start Button
B Stop Button
C Fault Reset
D Horn Reset
E Supplying Load
F Ready / Auto
G Warning
H Running
J Not in Auto
K Alarm
L Enter Button
M Down Button
Up Button
N
P Page Button
R LCD Display
S Mode Left
T Mode Right
S
K
J H
Works in MANUAL MODE only. Press this button to initiate the start sequence
of the engine.
Works in MANUAL MODE only. Press this button to initiate the stop sequence
of the engine. Repeated pressing or holding the button for more than 2
seconds will cancel current phase of the stop sequence (like ramping the
power down or cooling) and next phase will continue.
Use this button to acknowledge alarms and deactivate the horn output. Inactive
alarms will disappear immediately and status of active alarms will be changed
to "confirmed" so they will disappear.
Use this button to deactivate the horn output without acknowledging the alarms.
This LED is not used on these models.
Indicates the generator is in AUTO mode and ready for operation.
Indicates a generator warning is present.
Indicates generator is running.
Indicates the generator is not in AUTO mode.
Indicates a generator alarm is present.
Use this button to finish editing a setpoint or moving "right" in the history page.
Use this button to move down or decrease a value.
Use this button to move up or increase a value.
Use this button to switch over display pages.
Black/White display screen.
Use this button to change the mode. The button works only if the main screen
with the indicator of currently selected mode is displayed.
Use this button to change the mode. The button works only if the main screen
with the indicator of currently selected mode is displayed.
T
G F E
Description
A
B
C
D
3