Step
1. Ensure that the unit is unplugged before filling with water. Fill
with warm water to the fill line located on the inside of the tub. Colder
water colud take up to 20 minutes or longer to warm up than warm
water. For a quicker Heat Boost, fill with warm water. Once water
reaches selected temperature, it will stay at this temperature for as
long as heat function is selected.
Step
2. Plug the unit into a 120-volt household outlet.
Step
3. Sit down in a comfortable position. Press Power(P), then select
your desired feature by pressing the corresponding button. Press
(a,b,c) once to turn feature on. Press again to turn feature off
Note: The unit is equipped with a 30 minute auto shut-off.
a. Bubble Massage
b. Vibration Massage
c. Heat Boost – Press the Heat Boost button to select this feature.
Button will illuminate when selected. Note: Heat Boost will only work if
bubbles and/or vibration are selected. Press ↑↓arrows to choose heat
level.
- L 1 – low setting – maximum temperature 98°F (37°C)
- L 2 – medium setting – maximum temperature 104ーF (40°C)
- L 3 – high setting – maximum temperature 110ーF(43°C)
Note: Always test water temperature before fully submerging feet into
water.
INSTRUCTIONS FOR USE
FB675
(P)
(c)
(a)
(b)