Advertisement
Installation Verification and Run Test
Has the indoor unit been firmly installed?
Have you done the refrigerant leak test?
Is thermal insulation sufficient?
Does the unit drain appropriately?
Is the voltage in accordance with the rated voltage
marked on the nameplate?
Is the electric wiring and piping connection installed
correctly and securely?
Has the unit been connected to a secure earth
connection?
Has the proper power cord been specified?
Has the inlet and the outlet been covered?
Has the length of connection pipes and refrigerant
charge been recorded?
Before run test
Do not apply power before installation has been completed.
Electric wiring must be connected correctly and securely.
Connection piping shut-off valves should be in open position.
The unit must be rid of all debris and scrap.
Run test
Press the "ON/OFF" button on the wireless remote control to initiate operation.
Press the MODE button to select COOL, HEAT, FAN to verify the normal operation of the unit.
MS-SVN047B-EN
Items to verify:
Installation Verification and Run Test
Possible problems they generate:
The unit may drop, shake or emit noise
It may cause insufficient cooling/heating capacity
It may cause condensation and dripping
It may cause condensation and dripping
It may cause electric malfunction or damage the
unit
It may cause electric malfunction or damage the
unit
It may cause electric current leakage
It may cause electric malfunction or damage to unit
It may cause insufficient cooling/heating capacity
Refrigerant charge will be inadequate
15
Advertisement
