Philips HP6368 Manual page 8

ENGLISH
8 8
- When the batteries are empty, the battery low light goes out and the appliance stops.
Charge the batteries immediately.
-
4 times.
1 To attach the shaving head, slide it into the guiding grooves on both sides of the opening
in the handle. Then press the shaving head onto the appliance ('click') (Fig. 5).
2 To detach the shaving head, pull it off the appliance (Fig. 6).
Caution: Do not exert excessive pressure on the double shaving foil to avoid damage.
1 To attach the precision trimming head, slide it into the guiding grooves on both sides of
the opening in the handle. Then press it onto the appliance ('click') (Fig. 7).
2 To detach the precision trimming head, hold it at the protrusions while you pull. (Fig. 8)
1 To attach the 3mm or 5mm comb onto the precision trimming head, place the teeth of
the comb onto the teeth of the trimming head and push down the comb ('click'). The
precision trimming head (Fig. 9).
2 To detach the 3mm or 5mm comb, slide it forward with your thumb (Fig. 10).
Note: You cannot use the Ladyshave while it is connected to the mains.
Note: When you use the appliance for shaving, you can use it under both dry and wet conditions.
1 Place the double shaving foil and the integrated trimmer gently on the skin. Stretch the
skin with your free hand while you shave your bikini line. (Fig. 11)
2 Move the appliance slowly over the skin against the direction of hair growth while you
press it lightly. Make sure that the trimmer and the double shaving foil are always in full
contact with the skin (Fig. 12).
before you start to shave.
Caution: Never apply any cream or foam before you start to shave under dry conditions.