Cockpit Assembly - S-WORKS TT 2020 User Manual

COCKPIT ASSEMBLY

Choose the desired stack height, and which stack parts are needed to
„
reach the desired height (see tables on page 12).
21
SHIMANO OR
SRAM WIRE
6° OR 10°
SHIM
SPACER
STACK
Fig.21: 0-35mm stack.
„
• Install the left or right spacers onto the basebar, with the wire coming up the
middle hole of the spacers. Place a 6
by the correct extension socket for the left or right side.
The extension sockets are left and right specific.
• Place a conical washer in the extension socket, then install the appropriate
length bolt (to match the stack height) through the extension socket, shim (if
installed) and stack spacers.
• Place a nut underneath the basebar and thread the bolt into the nut.
• Install the 2nd bolt and conical washer, followed by the nut on the underside.
• Repeat the steps for the 2nd stack.
10
BOLT
CONICAL WASHER
EXTENSION
SOCKET
NUT
° °
or 10 shim on top (if desired), followed
22
SHIMANO OR
SRAM WIRE
CONICAL
WASHER
6° OR 10°
SHIM
BRIDGE
SPACER
STACK
Fig.22: 40-145mm stack.
„
• Install the 40, 80 or 120mm spacer onto the basebar, insert the sleeves under
the basebar, then thread two 32mm bolts into the spacer from below.
• Place any additional spacers on top of the 40, 80 or 120mm spacer that's
bolted in place, followed by the bridge (50-145mm stack), a 6
desired) and the correct extension socket for the left or right side.
• Once in position, install the conical washers and appropriate length bolts to
match the stack height.
• Repeat the steps for the 2nd stack.
23
SHIMANO Di2 WIRE
FIG. 23 (Shimano Di2): Route the extension wires
• At this point, the wiring coming up from the basebar should be exiting the
center hole of the extension socket. Continue running the wire through the
extension socket until it comes out the front.
BOLT
EXTENSION
SOCKET
SLEEVE
32mm BOLT
°
WIRE
THROUGH
HOLE
°
or 10 shim (if