Constitutes And Names Of Every Part Of Indoor Unit - Gree GMV-ND22C/A-T Owner's Manual

Multi Variable Air Conditioners Console Type Indoor Unit
NOTES!
① Use copper wire only as unit's power cord. Operating temperature should be within its rated
value.
② If the power cord is more than 15m long, please increase properly the sectional area of
power cord to avoid overload, which may cause accident.
③ Above selection requirements: Power cord size is based on BV single-core wire (2~4pc) at
40°C ambient temperature when laying across plastic pipe. Air switch is D type and used at
40°C. If actual installation condition varies, please lower the capacity appropriately
according to the specifications of power cord and air switch provided by manufacturer.
④ If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
⑤ Install cut-off device near the unit. The minimum distance between each stage of cut-off
device should be 3mm (The same for both indoor unit and outdoor unit).

3 Constitutes and Names of Every Part of Indoor Unit

CAUTION!
① Before opening the front panel, be sure to stop the operation and turn the breaker
OFF.
② Do not touch the metal parts on the inside of the indoor unit, as it may result in injury.
(1) Titanium Apatite Photocatalytic.
Air-Purifying Filter:
These filters are attached to the inside of the air filters.
(2) Air outlet.
(3) Display.
(4) Front panel.
(5) Louvers (vertical blades).
The louvers are inside of the air outlet.
(6) Air inlet.
(7) Air filter.
(8) Flap (horizontal blade).
(9) Cool mode lamp.
(10) Heat mode lamp.
(11) Dry mode lamp.
(12) Run lamp.
(13) LED display.
(14) Indoor Unit ON/OFF switch:
1) Push this switch once to start operation.
2) Push once again to stop it.
3) The operation mode refers to the following table.
13