Advertisement
Installation - (Current Fireplace)
1. Gain access to the component area of the fireplace (see installation manual for details).
2. Locate the LED power supply. Disconnect the Molex connector from the "power in" on the fireplace. Cut the
Red and Green wires just below the connectors. Remove and Replace the power supply.
Cut the Red and Green wires
just below the connectors
Disconnect "Power In"
& discard
3. Crimp the connectors included with this kit on to the red and green wires.
Crimp the male connector on to the RED wire and the female connector
IMPORTANT
on to the GREEN wire
4. Connect the RED and GREEN wires to the corresponding connectors on the power supply (RED to RED,
GREEN to BLACK).
POLARITY DOES MATTER. The RED LED wire to the RED power supply wire. The GREEN
LED wire to the BLACK power supply wire.
Restore the fireplace to its correct configuration.
5.
Page 3 of 3
DaVinci LED Power Supply
Red
Green
Red
Green
17602224 - 9/13/2021
sku# 250-05849
IMPORTANT
Red
Black
© Travis Industries, Inc.
Advertisement
