Page 1
(1) male (1) female Overview This kit provides the parts and information needed for updating or replacing the LED power supply in a DaVinci fireplace. This power supply will be a smaller and quieter replacement for the older power supplies or a direct replacement for newer units.
Page 2
DaVinci LED Power Supply sku# 250-05849 Second Generation Power Supply Disconnect LED XFMR Disconnect “Power In” & discard 3. Crimp the connectors included with this kit on to the LED XFMR wires Crimp the male connector on to the BLACK wire and the female connector...
Page 3
DaVinci LED Power Supply sku# 250-05849 Installation - (Current Fireplace) 1. Gain access to the component area of the fireplace (see installation manual for details). 2. Locate the LED power supply. Disconnect the Molex connector from the “power in” on the fireplace. Cut the Red and Green wires just below the connectors.