Honeywell HW2CESAWW9 User Manual page 16

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER CONTROL
While the unit is turned on, press the timer button and then press the + or - to select the number of
hours you would like the unit to continue to run. The unit will turn off automatically.
AUTO TURN OFF:
While unit is running, press the
press the + or - button to select the number of hours after which you want the unit to turn OFF
automatically.
AUTO TURN ON:
When the unit is in a standby mode, press the
select the number of hours until you want the unit to automatically start running.
Note: The time is adjustable between 1 - 24 hours.
WATER FULL LIGHT
Condensate may accumulate in the unit.
If the internal tank becomes full, the Water Full Light
the tank has been drained (refer to the "Water Condensate Drainage" section).
WARNING LIGHT
Condensate may accumulate in the unit.
If the internal tank becomes full, the warning light will flash and beep 10 times. The unit will not
operate until the unit has been drained (refer to Water Condensate Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
first and then the display will flash. While the display is flashing,
button first and then press the + or - button to
will illuminate. The unit will not operate until
EN 9